Convert A Freezer Into Built In Kegerator Fridge

Apr 3rd

Install Gas Regulator; Let your bar rest several hours. Place a disc in the clutch nut, which is attached to the regulator. Screw the nut to the valve outlet of the cylinder and tighten it with a wrench. Turn off the closed valve. Open the drum cylinder valve. Turn the adjusting screw clockwise until the meter shows the correct pressure. Attach to barrel to barrel clutch. Open the valve on the tank of CO2. Put the shut-off valve handle on the regulator in the open position. Hint; clean the built-in keg system on a regular basis. Use a particular cleaning kit that contains chemicals made for barrel parts. Meanwhile, how to connect a built in kegerator? Connect CO2 into the barrel. First, connect the CO2 regulator to the actual aquarium CO2.

You Maybe Interested In:  Barn Door Sliders Types

Built in kegerator – To make a built-in barrel refrigerator, or”kegerator”, out of the freezer, you must first convert it to a refrigerator. Simply follow some basic actions to build your own barrel fridge. Instructions is, covert Freezer for refrigerator: Please locate the connector using three pins on the temperature controller. Plug it into a wall outlet near the freezer. Insert the temperature control plug into the freezer power cord. Put the temperature regulator sensor around or through the door seal the freezer. Put the temperature of 36 to 40 degrees Fahrenheit.

Chest freezer kegerator size,

This will control how much CO2 is to be delivered to the barrel. (Depending on the type and volume of beer, this will vary. Read the instructions on the barrel to determine how much CO2 is going to be used.) Connect the controller to the CO2 line. A plastic pipe that sends CO2 into the barrel. Connect the other end of the line into the input valve in the barrel. Drop the barrel. Do put the keg into the authentic keg, which will lie on the barrel. Run the beer line from the keg press to the beer faucet where you wish to feed beer. Set the barrel in the refrigerator and close the door. This will keep the barrel chilled while in use. To pour a test glass of beer, open the beer faucet. And the built in kegerator was connect now.

You Maybe Interested In:  Red Cedar Picnic Table

Fit the parts. Drill a 1, 15/16 or 7/8 inch hole in the side wall or die of the converted freezer into built in kegerator fridge. Insert the shaft into the hole from the outside and fasten it with a lock nut. Attach to the handle of the crane head. Insert a rubber disc into the lock nut. Add another lock nut to the other side of a beer line jumper. Place a rubber disc here too. Attach hexagon nuts to barrel clutch top and shaft is back. Hold the air conduit, mount one end of the nipple of the barrel connector. Attach thread with screwdriver. Pick out the air line’s other end and press over the nipple regulator. Attach the airline with a screwdriver.

This gallery is about built in kegerator.