Installing Kitchen Exhaust Hood

Jan 18th

Once you have mounted the fan and lighting mounting on site, make the electrical connections needed to operate the equipment. Run current from an current source if available, or add a circle by tying to a nearby connector box. Scale the cables. Combine the white wire from the hood to the white (neutral) circuit wire, using a thread nut. Do the same with the black cable and black (hot) warp wire. Join the ground to an current ground wire. Secure the circuit cable, then turn on the power and examine the circuit before replacing the cover plate to the electric window again with fan range and light kitchen exhaust hood.

You Maybe Interested In:  Patio Shade Covers Styles

Specify where the mounting screws were with the new kitchen exhaust hood as a template. The hood is usually mounted to the bottom of the cabinet above the variety, but some models mount on the wall or ceiling above the range. If mounting a hood as an exhaust system to the outside, make sure that it’s in keeping with the duct system in the cabinet, wall or ceiling. Attach the mounting screws but do not tighten them completely. You are able to move the hood slightly, as a result of this keyhole-shaped mounting holes in the hood. Finish tighten the screws when everything is setting properly.

Kitchen exhaust hood – Range fans, also called hoods, cut down on smells by reducing the steam, smoke and grease created by boiling. Mounted over the stove, either these units recycle the air back into the kitchen after filtering it or exhaust the air outside the home. Circulation models are easier to install, but do not do much work to eliminate fat and odors. Before installing, turn off power to the area where you will mount the fan and test the fan power lines with a non-contact voltage tester to confirm that the power is turned off. Guard your selection by draping a thick blanket over it.

You Maybe Interested In:  Where To Buy A Jenny Lynn Crib

If you replace a recycled kitchen exhaust hood with an outdoor consume, you will probably need to install a channel behind the wall or ceiling surface or through the cabinet. The placement of wall or ceiling framing determines which option works best for your application. Mark the site, then cut through plaster or plywood. You are able to direct the channel through the wind and beyond the roof or through an outside wall. Both of these options mean cutting through external material – either sideways or roofing – to complete the installation.

This gallery is about kitchen exhaust hood.