Place one of 18 with 18 inch tables board up and down the surface. Set the two leg sets in addition to the table, with exactly 10 inches of clearance between the two collections of articles. Center the long dimension of the leg service plank between the borders of the table . Drill four holes each leg service plank and into the table . Attach largest boards into the table with 1 1/4 inch wood screws trimmed in each pit.
Side table with drawers stand up two 2 by two after 24 inch articles and also have an assistant maintain them parallel to each other, in order there is a distance between these 10 inches. Put a 1/2 with 3 with 16 inches board with their side on the poles. Center the plank in addition to the articles in both short and long dimensions. Drill a hole through the top of this discussion and at each leg pole. Attach the leg service plank into the articles with 1 1/4″wood screws. Repeat for a different set of 2 articles and a plank.
Arrange four 1/2 with 4 of 11 1/2 inch disks in a perfect square of side table with drawer, with their endings touching one end to side repetitive patterns so the last measurement of this square is 12 by 12 inches. Drill two holes in each joint, throughout the outside of a plank and towards the conclusion of the adjoining board. Fasten the planks with 1 1/4″wood screws.
Side table with drawer is a item of furniture. This design allows for customization of measurements and also the number of drawers installed. Tweaking these options will create unique furniture which perfectly fits the space and its requirements.
Place the box at the 12-inch gap between both side tables with drawer legs. Mark the location of the base plate of the box onto the inside of each table . Take the box out and then hold a 1/2 with 1/2 with 12-inch plank against each other markers so the surface of the plank is also with the mark. Drill a hole through each plank and right to each leg it rolls. Twist the box in addition to these boards and replicate for additional boxes.
Establish a 1/2 with 12 with 12-inch plank in addition to the square framework. Drill holes through the board and at the framework evenly distributed every four inches. Attach the board to the framework with 1 1/4″wood screws. Stand upright on a small end. Put a 2/1 of 5 with 13-inch on board evenly on top of this box. Twist four holes throughout the inside of the box framework and to this top plank, that is the box . Attach the box frame to the framework with 3/4 inch wood screws.
This gallery is about side table with drawers.